Synthetic enamel Ferromicaceo anti-corrosive antique finish.Effect ferrobattuto.

ANTIQUUS is a nail Polish plastic synthetic fine high-gloss, coverage and distensibility. The durability
color is the durability of the gloss make it ANTIQUUS suitable for indoor and outdoor applications both on the wood
on the iron.
APPLICATION CYCLES
New iron:
To rust the needle to facilitate the removal of mill scale, do a thorough brushing to remove the
rust is present, apply two coats of FERRUS and apply two coats of ANTIQUUS according to the directions
in the tab technique.
Old iron is already painted:
Brush and/or sandpaper paying special attention to the parts that have rust, touch up the parts that have
rust with FERRUS , if the rust is extensive, apply a coat of FERRUS on the entire surface , apply two coats
of ANTIQUUS according to the indications given in the technical data sheet.
New wood:
Sand carefully to the wood , apply a coat of primer OPACUS and sanding back the support,
apply two coats of ANTIQUUS according to the indications given in the technical data sheet.
Wood previously painted:
Sand thoroughly the surface to remove the inconsistencies from the support, apply a coat of primer
OPACUS and sand again the support, apply two coats of ANTIQUUS according to the instructions in the
the technical data sheet.
WARNINGS
CLASSIFICATION VOC
Work in well ventilated areas while wearing proper means of individual protection (mask). Operation
sanding, welding, removing, burning off old paint, may generate dust and/or hazardous fumes.
Paint finishes and cladding interior - exterior for wood , metal, or plastic .
Limit value EU VOC directive (2004/42/CE) for these products (cat. A/d, type BS) : 300 g/l (2010).
This product contains a maximum of 300 g/l of VOCS.
Because the conditions and possibilities of employment can be affected by elements outside the control of the manufacturer, the Damaskolor Srl
does not assume any responsibility for the results.
 
YIELD :14-16 mq/lt

READY-TO-USE